Table of Contents
Advertisement
JunosE 11.2.x Broadband Access Configuration Guide
Verifying That a Locked-Out Destination Is Available
Configuring a Lockout Timeout
360
that includes a modified lockout timer, and a configuration with both a modified timer
and the lockout test.
Figure 9: Lockout States
You can use the following commands to manage L2TP destination lockout and configure
a lockout process that meets the needs of your network environment:
Use the l2tp destination lockout-timeout command to modify the default lockout
timeout period.
Use the l2tp destination lockout-test command to configure L2TP to perform a lockout
test, which verifies that a currently locked out destination is now available and to
include it in the selection algorithm.
Use the l2tp unlock destination command to force L2TP to immediately unlock the
specified locked out destination; the destination is then considered to be available by
the selection algorithm. L2TP disregards any time remaining in the existing lockout
timeout and also disregards the lockout test (if configured).
Use the l2tp unlock-test destination command to force L2TP to immediately begin
the lockout testing procedure for the specified destination; any time remaining in the
existing lockout timeout is not taken into account.
Use the show l2tp and show l2tp destination lockout commands to view information
about the L2TP configuration and statistics.
You can use the l2tp destination lockout-test command to configure L2TP to test
locked-out destinations; this verifies that a previously locked-out destination is available
before the router changes the destination's status.
To verify the availability of locked out destinations:
host1(config)#l2tp destination lockout-test
You use the l2tp destination lockout-timeout command to configure the amount of
time (in seconds) between when an L2TP destination is found to be unavailable and
when it is eligible for unlocking. When the timeout period expires, L2TP either begins the
lockout test procedure (if configured to do so) or immediately returns the destination to
available state.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
