Table of Contents
Advertisement
•
4.2 ONS 15200 Network Configuration
This section describes how to set up the NCB module so you can communicate with the MCU and SCUs.
It also describes how to configure the ONS 15200 network.
Procedure: Configure the Network
Step 1
Using a CIM RS-232 cable, connect the laptop to the management access (MA) port on the
Communication Interface module (CIM). See
Cisco ONS 15200 Installation, Setup, and Test Manual
4-2
To manage an MCU, the following items are required:
–
CAN accessory kit (p/n 800-20162-01, includes the CAN board, CAN cable, and CAN LAN
cable)
–
Cisco ONS 15200 Maintenance Manager CD-ROM (p/n 85-2510-01) software installed on a PC
–
Crossover Ethernet cable for direct connection to the NCB (optional)
Figure
4-1.
Chapter 4
Turn Up and Test
78-13765-01
Advertisement
Table of Contents
