Ntp-B156 Convert A Point-To-Point Or Linear Adm To A Path Protection - Cisco ONS 15327 Procedure Manual

NTP-B156 Convert a Point-to-Point or Linear ADM to a Path Protection

c.
Verify that the working slot is carrying traffic (Working/Active).
Step 4
Note
When the working slot is carrying traffic, clear the manual switch:
Step 5
a.
b.
Step 6 Verify that the working slot does not switch back to Standby, which might indicate a problem on the
working span.
Step 7 Return to your originating procedure (NTP).
NTP-B156 Convert a Point-to-Point or Linear ADM to a Path
Protection
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This procedure is service affecting. All circuits are deleted and reprovisioned.
Caution
Log into a node on the point-to-point or linear ADM. See the
Step 1
page
Check for alarms and conditions. See the
Step 2
task on page 12-3
Complete the
Step 3
Complete the
Step 4
that supports the point-to-point or linear ADM span.
Complete the
Step 5
in all nodes.
Complete the
Step 6
Automatically Routed Optical Circuit" procedure on page 5-39
a time.
Caution Deleting circuits is service affecting.
Cisco ONS 15327 Procedure Guide, R4.0
12-6
Click Yes in the confirmation dialog box.
If the slot is not active, look for conditions or alarms that might be preventing the card from
carrying working traffic. Refer to the Cisco ONS 15327 Troubleshooting Guide.
In the Switch Commands field, choose Clear.
Click Yes in the confirmation dialog box.
This procedure upgrades a point-to-point system to a path protection.
None
None
As needed
Onsite
Provisioning or higher
2-23.
for instructions.
"DLP-B189 Verify that a 1+1 Working Slot is Active" task on page 12-5
"DLP-B155 Delete a Protection Group" task on page 9-14
"DLP-B253 Provision SONET DCC Terminations" task on page 4-5
"NTP-B152 Delete Circuits" procedure on page 8-15
Chapter 12
"DLP-B60 Log into CTC" task on
"DLP-B298 Check the Network for Alarms and Conditions"
to delete and recreate the circuits one at
Convert Network Configurations
for each node.
for each 1+1 protection group
at the protect cards
and the "NTP-B188 Create an
March 2003