Xerox WorkCentre 5687 Series Service Manual page 207

– Figure 8, check the registration ground contact spring and ground wire terminal. If
necessary remove and clean the spring, shafts and bearings, then re-assemble to
improve continuity
Figure 8 Registration ground contact spring
WorkCentre 5687 Family
Registration ground
contact spring
Ground wire terminal
August 2007
– Figure 9, bypass paper tray guide. Check for continuity of less than 2k ohms
between the ground contact spring and the lift plate (Figure 10). Check for continuity
of less than 1 ohm between the bypass paper guide and the main frame ground con-
nection, when the left hand door is closed. To improve continuity, disconnect the
ground terminals clean the spring contact faces and re-assemble, to improve conti-
nuity. Also check and clean, if necessary the part of the machine frame where the
ground contact spring makes contact.
Figure 9 Bypass tray guide
2-15
Bypass paper guide.
Ground contact spring.
Status Indicator RAPs
01A