Iot Exit Jam - Xerox Phaser 6500 Service Manual

Error Messages and Codes

IOT Exit JAM

Applicable Error Code
3-134
• 077-900
Troubleshooting Reference Table
Applicable Parts
Fuser Assy (PL6.1.1)
■
Fuser Harness Assy (PL6.1.2)
■
MCU Board (SFP PL8.2.13; MFP
■
PL8.3.6)
Warning
To avoid possible burns, allow the Fuser Assy to cool before beginning the
procedure.
Troubleshooting Procedure
Step Actions and Questions
1 Check paper feeding
Was paper fed from the Manual Feed
slot?
2 Was the paper inserted straight into
the Manual Feed slot and not at an
angle?
3 Does the error still occur when
printing?
4 Check the paper condition
Is the paper wrinkled or damaged?
5 Does the error still occur when
printing?
6 Reload with new paper.
Does the error still occur when
printing?
Xerox Internal Use Only
http://www.manuals4you.com
Wiring and Plug/Jack Map References
"Map 1 - SFP Print Engine" on
■
page 10-6
"Map 4 - SFP MCU Board" on
■
page 10-9
"Map 6 - MFP Print Engine" on
■
page 10-15
"Map 9 - MFP MCU Board and HVPS"
■
on page 10-18
"SFP Fuser" on page 10-33
■
"MFP Fuser" on page 10-46
■
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Replace with
new, dry paper,
then go to step
5.
Go to step 7.
Go to step 7.
Phaser 6500/WorkCentre 6505 Service Manual
No
Go to step 4.
Insert paper
straight into
the Manual
Feed slot, and
go to step 3.
Complete.
Go to step 6.
Complete.
Complete.