Xerox WorkCentre 5687 Series Service Manual page 205

– Figure 4, DADH ground connection. Remove the DADH rear cover, PL 5.10 Item 1.
Check for continuity of less than 1 ohm between the DADH frame and the main
frame ground connection. To improve continuity, check that the hardware is tight and
the harness crimping is good. If necessary disconnect the terminals, clean the con-
tact faces and re-assemble, to improve continuity.
Right hinge ground connection
Auxiliary DADH ground con-
nections
Main DADH ground
connection
Figure 4 DADH ground connection
WorkCentre 5687 Family
–
Motor ground
connections
Left hinge ground
August 2007
2-13
Figure 5, paper path ground check points. With the duplex transport in the latched
position, check for continuity of less than 1M ohms between the ends of the three
duplex roll shafts, the steel frame of the duplex path and the main frame ground con-
nection. Also check for continuity of less than 10 ohms between the steel frame of
the duplex path and the ends of the three duplex roll shaft. To improve continuity,
remove the duplex transport, REP 8.7.
Duplex roll shafts and the steel frame of duplex path.
Figure 5 Paper path ground check points
NOTE: The (32-55 ppm) duplex transport is shown in Figure 6. The (65-87 ppm)
duplex transport has a duplex duct, PL 8.20 Item 12 installed.
Status Indicator RAPs
01A