Rear Gate Glass - Subaru 2003 LEGACY Service Manual

GLASS/WINDOWS/MIRRORS

11.Rear Gate Glass

A: REMOVAL
1) Remove real wiper motor. <Ref. to WW-16, REMOVAL, Rear Wiper Motor.>
2) Remove connector from rear defogger terminal.
3) Remove glass in the same procedure as for windshield glass. <Ref. to GW-19, REMOVAL, Windshield
Glass.>
NOTE:
Rear gate glass is a single unit of both glass and molding. Replacing only molding or glass is not allowed.
B: INSTALLATION
1) Apply adhesive evenly to the glass attachment area.
2) Insert the glass clip pin into the rear gate hole, and after pushing on the area around the clip pin to secure
it, push lightly all around the area to seal it.
3) About one hour after installation, conduct a leak test.
( 3 )
( 2 )
( S )
( 1 )
( 2 )
(1) Clip
(2) Adhesive
(3) Molding
REAR GATE GLASS
( 4 )
( B )
( S )
( 3 )
(4) Glass
(5) Primer
( A )
( 3 )
GW-22
( S )
( 2 )
10mm
(0.39in)
(A) Primer application location (left
and right)
(B) Primer application location (lower)
GW-00201