Rear Gate Glass - Subaru Legacy 2002 Service Manual

Hide thumbs Also See for Legacy 2002:

Table of Contents

11. Rear Gate Glass

1) Remove real wiper motor. <Ref. to WW-16,

REMOVAL, Rear Wiper Motor.>

2) Remove electrical connector from rear defog-

ger terminal.

3) Remove glass in the same procedure as for

windshield glass. <Ref. to GW-20, REMOVAL,

Windshield Glass.>

B: INSTALLATION

1) Apply adhesive evenly to the glass attachment

2) Insert the glass clip pin into the rear gate hole,

and after pushing on the area around the clip pin

to secure it, push lightly all around the area to seal

3) About one hour after installation, conduct a leak

REAR GATE GLASS

¼ When door is opened/closed after glass is

bonded, always lower door glass and then

open/close it carefully.

¼ Move vehicle slowly.

4) After completion of all work, allow vehicle to

stand for about 24 hours.

For minimum drying time and time the vehicle must

be left standing before driving after bonding, follow

instructions or instruction manual from the adhe-

sive manufacturer.

When a vehicle is returned to the user, tell him

or her that the vehicle should not be subjected

to heavy impact for at least three days.

5) Connect rear defogger terminals.

INSTALLATION, Rear Wiper Motor.>

Glass/Windows/Mirrors

Table of Contents