Parameters With "Khp_Active_Read - Siemens SINAMICS G120D CU240D-2 DP Manual

2 Parameters
2.5 Parameters for write protection and know-how protection
p8983
p9400
p9484
2.5.3

Parameters with "KHP_ACTIVE_READ"

The following list contains the parameters with the "KHP_ACTIVE_READ" attribute.
These parameters can also be read with activated know-how protection.
Product: SINAMICS G120D, Version: 4707900, Language: eng, Type: KHP_ACTIVE_READ
p0015
p0100
p0170
p0180
p0300[0...n]
p0304[0...n]
p0305[0...n]
p0400[0...n]
p0505
p0595
p0730
p0731
p0806
p0922
p1080[0...n]
p1082[0...n]
p1520[0...n]
p2000
p2001
p2002
p2003
p2005
p2006
p2007
p2030
p2038
p2079
p7763
p7764[0...n]
p9601
p9810
588
Ethernet/IP ODVA torque scaling / Eth/IP ODVA M scal
Safely remove memory card / Mem_card rem
BICO interconnections search signal source / BICO S_src srch
Macro drive unit / Macro drv unit
IEC/NEMA mot stds / IEC/NEMA mot stds
Number of Command Data Sets (CDS) / CDS count
Number of Drive Data Sets (DDS) / DDS count
Motor type selection / Mot type sel
Rated motor voltage / Mot U_rated
Rated motor current / Mot I_rated
Encoder type selection / Enc_typ sel
Selecting the system of units / Unit sys select
Technological unit selection / Tech unit select
BI: CU signal source for terminal DO 0 / CU S_src DO 0
BI: CU signal source for terminal DO 1 / CU S_src DO 1
BI: Inhibit master control / PcCtrl inhibit
PROFIdrive PZD telegram selection / PZD telegr_sel
Minimum speed / n_min
Maximum speed / n_max
CO: Torque limit upper / M_max upper
Reference speed reference frequency / n_ref f_ref
Reference voltage / Reference voltage
Reference current / I_ref
Reference torque / M_ref
Reference angle / Reference angle
Reference temp / Ref temp
Reference acceleration / a_ref
Field bus int protocol selection / Field bus protocol
PROFIdrive STW/ZSW interface mode / PD STW/ZSW IF mode
PROFIdrive PZD telegram selection extended / PZD telegr ext
KHP OEM exception list number of indices for p7764 / KHP OEM qty p7764
KHP OEM exception list / KHP OEM excep list
SI enable functions integrated in the drive (processor 1) / SI enable fct P1
SI PROFIsafe address (processor 2) / SI PROFIsafe P2
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313