Siemens SINAMICS G120D CU240D-2 DP Manual page 165

p1056[0...n] BI: Jog bit 1 / Jog bit 1
CU250D-2_PN_F Access level: 3
CU250D-2_DP_F
Can be changed: T
Unit group: -
Min
-
Description: Sets the signal source for jog 2.
Recommendation: When the setting for this binector input is changed, the motor can only be switched on by means of an appropriate
signal change of the source.
Dependency: Refer to: p0840, p1059
Notice: The drive is enabled for jogging using BI: p1055 or BI: p1056.
The command "ON/OFF1" can be issued using BI: p0840 or using BI: p1055/p1056.
Only the signal source that was used to switch on can also be used to switch off again.
p1058[0...n] Jog 1 speed setpoint / Jog 1 n_set
Access level: 2
Can be changed: T
Unit group: 3_1
Min
-210000.000 [rpm]
Description: Sets the speed for jog 1.
Jogging (JOG) is level-triggered, and allows the motor to be incrementally traversed.
Dependency: Refer to: p1055, p1056
p1059[0...n] Jog 2 speed setpoint / Jog 2 n_set
Access level: 2
Can be changed: T
Unit group: 3_1
Min
-210000.000 [rpm]
Description: Sets the speed for jog 2.
Jogging (JOG) is level-triggered, and allows the motor to be incrementally traversed.
Dependency: Refer to: p1055, p1056
p1063[0...n] Setpoint channel speed limit / Setp_chan n_lim
Access level: 3
Can be changed: U, T
Unit group: 3_1
Min
0.000 [rpm]
Description: Sets the speed limit effective in the setpoint channel.
Dependency: Refer to: p1082, p1083, p1085, p1086, p1088
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: p0505
Max
210000.000 [rpm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
210000.000 [rpm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
210000.000 [rpm]
2 Parameters
2.2 List of parameters
Data type: U32 / Binary
Dyn. index: CDS, p0170
Func. diagram: 2501, 3030
Factory setting
0
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 3001, 3030
Factory setting
150.000 [rpm]
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 3001, 3030
Factory setting
-150.000 [rpm]
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 3040
Factory setting
210000.000 [rpm]
165