Assigning Parameters For Option Handling With Reserve Modules - Siemens SIMATIC ET 200S IM151-1 FO STANDARD Manual

Functions
3.1 Option handling with RESERVE modules
3.1.4

Assigning parameters for option handling with RESERVE modules

Introduction
STEP 7
In
you want to use in future applications, e.g. 4DI H, on the RESERVE module slots (or the
expansion modules on the right-hand end of the station):
● Drag the electronic module to the configuration table
● Assign the parameters
Procedure
1. Drag a PM-E 24..48 VDC or PM-E 24..48 VDC/24..230 VAC power module with one of
2. Assign parameters to the interface module as follows:
Interface module
IM151-1
STANDARD
or
IM151-1 FO
STANDARD
or
IM151-1 HIGH
FEATURE
Note
If "Operation for set < > actual installation" is blocked for parameter assignment,
 the ET 200S does not start up if a module is missing or if an incorrect module is plugged
 The ET 200S starts up if you enable option handling for the slot where a RESERVE
18
COM PROFIBUS
or
the following entries into the configuration table:
– ...O (option handling) or
– ...SO (status byte + option handling)
Note
Entry of the power module with the ending ...O or ...SO can only be made once in the
ET 200S configuration!
Parameter
Option handling,
general
Option handling:
Slots 2 to 63
Option handling:
With/without
RESERVE modules
in. The diagnostic "No module" or "Incorrect module" is signaled.
module is plugged in. A diagnostic is not signaled.
you assign the parameters for the electronic modules which
Setting
enable
Enable (all the slots
where RESERVE
modules can be located)
With RESERVE
modules
IM151-1 FO STANDARD interface module (6ES7151-1AB05-0AB0)
Description
Option handling is activated for
the entire ET 200S.
There are RESERVE modules
or a configured electronic
module on the slot. A diagnostic
is not signaled.
Selects option handling with
RESERVE modules
Manual, 02/2010, A5E01075965-03