Siemens SINAMICS G120D CU240D-2 DP Manual page 427

Note: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
For p8808[0...53]:
Any supplementary information and comments (ASCII).
p8809[0...53] Identification and Maintenance 4 / I&M 4
CU240D-2_PN Access level: 3
CU240D-2_PN_F
Can be changed: U, T
CU250D-2_PN_F
Unit group: -
Min
0000 bin
Description: Parameters for the PROFINET data set "Identification and Maintenance 4" (I&M 4).
This information is known as "Signature".
Dependency: This parameter is pre-assigned as standard (see note).
After writing information to p8809, p8805 is automatically set to = 1.
Refer to: p8805
Note: For p8805 = 0 (factory setting) the following applies:
Parameter p8809 contains the information described below.
For p8809[0...3]:
Contains the value from r9781[0] "SI change tracking checksum functional".
For p8809[4...7]:
Contains the value from r9782[0] "SI change tracking time stamp checksum functional".
For p8809[8...53]:
Reserved.
r8854 PROFINET state / PN state
CU240D-2_PN Access level: 4
CU240D-2_PN_F
Can be changed: -
CU250D-2_PN_F
Unit group: -
Min
0
Description: State display for PROFINET.
Value: 0:
1:
2:
3:
4:
5:
6:
255:
r8858[0...39] PROFINET read diagnostics channel / PN diag_chan read
CU240D-2_PN Access level: 4
CU240D-2_PN_F
Can be changed: -
CU250D-2_PN_F
Unit group: -
Min
-
Description: Displays the PROFINET diagnostics data.
Note: Only for internal Siemens diagnostics.
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
No initialization
Fatal fault
Initialization
Send configuration
Receive configuration
Non-cyclic communication
Cyclic communications but no setpoints (stop/no clock cycle)
Cyclic communication
Calculated: -
Scaling: -
Unit selection: -
Max
1111 1111 bin
Calculated: -
Scaling: -
Unit selection: -
Max
255
Calculated: -
Scaling: -
Unit selection: -
Max
-
2 Parameters
2.2 List of parameters
Data type: Unsigned8
Dyn. index: -
Func. diagram: -
Factory setting
0000 bin
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
-
Data type: Unsigned16
Dyn. index: -
Func. diagram: -
Factory setting
-
427