Siemens SINAMICS G120D CU240D-2 DP Manual page 424

2 Parameters
2.2 List of parameters
Index: [0] = ON/OFF1
[1] = OC / OFF2
[2] = OC / OFF3
[3] = Operation enable
[4] = Ramp-function generator enable
[5] = Continue ramp-function generator
[6] = Speed setpoint enable
[7] = Acknowledge fault
[8] = Jog bit 0
[9] = Jog bit 1
[10] = Master control by PLC
[11] = Direction reversal (setpoint)
[12] = Enable speed controller
[13] = Motorized potentiometer raise
[14] = Motorized potentiometer lower
[15] = CDS bit 0
p8543 CI: Active speed setpoint in the BOP/IOP manual mode / N_act act OP
Access level: 3
Can be changed: T
Unit group: -
Min
-
Description: For the manual mode: Sets the signal source for the speed setpoint.
p8552 IOP speed unit / IOP speed unit
Access level: 3
Can be changed: T
Unit group: -
Min
1
Description: Sets the unit for displaying and entering speeds.
Value: 1:
2:
p8558 BI: Select IOP manual mode / Sel IOP man mode
Access level: 3
Can be changed: U, T
Unit group: -
Min
-
r8570[0...39] Macro drive object / Macro DO
Access level: 1
Can be changed: -
Unit group: -
Min
-
Description: Displays the macro file saved in the appropriate directory on the memory card/device memory.
Dependency: Refer to: p0015
Note: For a value = 9999999, the following applies: The read operation is still running.
424
Hz
rpm
Calculated: -
Scaling: p2000
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
2
Calculated: -
Scaling: -
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
Data type: U32 / FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
8541[0]
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
2
Data type: U32 / Binary
Dyn. index: -
Func. diagram: -
Factory setting
0
Data type: Unsigned32
Dyn. index: -
Func. diagram: -
Factory setting
-
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313