Siemens SINAMICS G120D CU240D-2 DP Manual page 108

2 Parameters
2.2 List of parameters
11:
12:
13:
14:
15:
16:
17:
18:
19:
20:
21:
22:
23:
24:
25:
26:
27:
28:
29:
30:
31:
32:
33:
34:
35:
36:
37:
38:
39:
40:
41:
42:
43:
44:
45:
46:
47:
Dependency: Only the unit of the technology controller parameters are switched over (unit group 9_1).
Refer to: p0596
Note: When switching over from % into another unit, the following sequence applies:
- set p0596
- set p0595 to the required unit
p0596 Technological unit reference quantity / Tech unit ref qty
CU240D-2_DP Access level: 1
CU240D-2_PN
Can be changed: T
CU240D-2_DP_F
Unit group: -
CU240D-2_PN_F
Min
0.01
Description: Sets the reference quantity for the technological units.
When changing over using changeover parameter p0595 to absolute units, all of the parameters involved refer to the
reference quantity.
Dependency: Refer to: p0595
Notice: When changing over from one technological unit into another, or when changing the reference parameter, a
changeover is not made.
108
m³/h
kg/s
kg/min
kg/h
t/min
t/h
N
kN
Nm
psi
°F
gallon/s
inch³/s
gallon/min
inch³/min
gallon/h
inch³/h
lb/s
lb/min
lb/h
lbf
lbf ft
K
rpm
parts/min
m/s
ft³/s
ft³/min
BTU/min
BTU/h
mbar
inch wg
ft wg
m wg
% r.h.
g/kg
ppm
Calculated: -
Scaling: -
Unit selection: -
Max
340.28235E36
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: -
Factory setting
1.00
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313