Download  Print this page

Siemens SINAMICS G120P Operating Instructions Manual

Du/dt fillter plus voltage peak limiter.
Hide thumbs

Advertisement

Advertisement

Table of Contents

   Summary of Contents for Siemens SINAMICS G120P

  • Page 3 ___________________ dV/dt filter plus Voltage Peak Limiter Safety information ___________________ General ___________________ Mechanical installation SINAMICS ___________________ Electrical installation SINAMICS G120P ___________________ dV/dt filter plus Voltage Peak Maintenance and servicing Limiter ___________________ Technical specifications Operating Instructions Control version V4.6 04/2014 A5E32847105B AB...
  • Page 4 Note the following: WARNING Siemens products may only be used for the applications described in the catalog and in the relevant technical documentation. If products and components from other manufacturers are used, these must be recommended or approved by Siemens. Proper transport, storage, installation, assembly, commissioning, operation and maintenance are required to ensure that the products operate safely and without any problems.
  • Page 5: Table Of Contents

    Table of contents Safety information ........................... 7 Warnings ............................7 Components that can be destroyed by electrostatic discharge (ESD) .......... 9 General ..............................11 Mechanical installation .......................... 15 Electrical installation..........................19 Maintenance and servicing ........................23 Technical specifications ........................25 dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 6 Table of contents dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 7: Safety Information

    Safety information Warnings WARNING Danger to life if the fundamental safety instructions and remaining risks are not carefully observed Non-compliance with the fundamental safety instructions and residual risks stated in Chapter 1 of the Installation Manual for PM330 Power Modules can result in accidents with severe injuries or death.
  • Page 8 1.1 Warnings Note Support by SIEMENS service centers We recommend engaging the support and services of your local Siemens service center for all planning, installation, commissioning and maintenance work. dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 9: Components That Can Be Destroyed By Electrostatic Discharge (esd)

    Safety information 1.2 Components that can be destroyed by electrostatic discharge (ESD) Components that can be destroyed by electrostatic discharge (ESD) CAUTION Components sensitive to electrostatic charge The board contains components that can be destroyed by electrostatic discharge. These components can be easily destroyed if not handled properly. If you do have to use electronic boards, however, please observe the following: •...
  • Page 10 Safety information 1.2 Components that can be destroyed by electrostatic discharge (ESD) dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 11: General

    General Description The du/dt filter plus voltage peak limiter comprises two components: the du/dt reactor and the Voltage Peak Limiter, which cuts off the voltage peaks and returns the energy to the DC link. The du/dt filters plus Voltage Peak Limiter must be used for motors for which the proof voltage of the insulation system is unknown or insufficient.
  • Page 12 When using components that have not been released, damage or malfunctions can occur at the devices or the system itself. • Only use du/dt filters that SIEMENS has approved for operation with SINAMICS. NOTICE Damage to the du/dt filter if it is not activated during commissioning The du/dt filter may be damaged if it is not activated during commissioning.
  • Page 13 General Components The order numbers of the individual components (du/dt reactor and voltage peak limiter) are listed in the following table: Table 2- 2 du/dt filter plus Voltage Peak Limiter, order numbers of the individual components du/dt filter plus Voltage Peak Limiter du/dt reactor Voltage limiting network Line voltage 380 V –...
  • Page 14 General Figure 2-1 Limiting the rate of voltage rise and the voltage peaks using an output reactor and du/dt filter plus Voltage Peak Limiter dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 15: Mechanical Installation

    Mechanical installation When the du/dt filter plus Voltage Peak Limiter is installed in a cabinet, it must be positioned near the Power Module. Dimension drawing Figure 3-1 Dimension drawing, du/dt reactor dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 16 Mechanical installation Table 3- 1 Dimensions of du/dt reactor, 380 V - 480 V 3 AC (all values in mm) 6SL3000- 2DE35-0CA0 2DE38-4CA0 14 x 18 14 x 18 152.5 152.5 hmax M12 (15 x 22) M12 (15 x 22) Lengths n1 and n2 correspond to the distance between holes Dimension drawing of the voltage peak limiter Figure 3-2...
  • Page 17 Mechanical installation Figure 3-3 Dimension drawing, voltage limiting network, order number 6SL3000-2DE38-4BA0 dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 18 Mechanical installation dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 19: Electrical Installation

    Electrical installation Interface overview Figure 4-1 Interface overview voltage limiting network, order number 6SL3000-2DE35-0BA0 dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 20 Electrical installation Figure 4-2 Interface overview voltage limiting network, order number 6SL3000-2DE38-4BA0 dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 21 Electrical installation Connection When connecting the du/dt reactor and Voltage Peak Limiter, you must take into account the following conditions to ensure that it functions correctly: ● Control cables must be routed separately from power cables. Power cables are the motor cable or the connecting cables from the DC link of the Power Module (terminals DCP/DCN) to the Voltage Peak Limiter.
  • Page 22 Electrical installation WARNING Risk of fire due to ground fault/short-circuit Inadequate installation of the cables to the Power Module DC link can result in a ground fault/short-circuit and place persons at risk as a result of the associated smoke and fire. •...
  • Page 23: Maintenance And Servicing

    Maintenance and servicing Maintenance and servicing are not carried out for the dv/dt reactor and the Voltage Peak Limiter. In the case of an error, full replacement of the dv/dt filter is necessary. dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 24 Maintenance and servicing dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...
  • Page 25: Technical Specifications

    Technical specifications General technical data Table 6- 1 General technical data Product standard EN 61800-5-1 Specific technical data Table 6- 2 Technical specifications for the du/dt filter plus Voltage Peak Limiter, 380 V – 480 V 3 AC Order number 6SL3000- 2DE35-0AA0 2DE38-4AA0...
  • Page 26 Technical specifications dV/dt filter plus Voltage Peak Limiter Operating Instructions, 04/2014, A5E32847105B AB...

Comments to this Manuals

Symbols: 0
Latest comments: