Siemens SINAMICS G120D CU240D-2 DP Manual page 269

Dependency: This parameter is only updated during the automatic calculation (p0340 = 1, p3900 > 0) if motor commissioning was
carried out beforehand for drive data set zero. This means that the parameter is not locked against overwriting using
p0573 = 1.
Note: If a BICO interconnection is established between different physical quantities, then the particular reference quantities
are used as internal conversion factor.
The reference acceleration is calculated as follows:
p2007 = p2000 / 1 [s]
p2010 Comm IF baud rate / Comm baud
Access level: 3
Can be changed: T
Unit group: -
Min
6
Description: Sets the baud rate for the commissioning interface (USS, RS232).
Value: 6:
7:
8:
9:
10:
11:
12:
Note: COMM-IF: Commissioning interface
The parameter is not influenced by setting the factory setting.
p2011 Comm IF address / Comm add
Access level: 3
Can be changed: T
Unit group: -
Min
0
Description: Sets the address for the commissioning interface (USS, RS232).
Note: The parameter is not influenced by setting the factory setting.
p2016[0...3] CI: Comm IF USS PZD send word / Comm USS send word
Access level: 3
Can be changed: U, T
Unit group: -
Min
-
Description: Selects the PZD (actual values) to be sent via the commissioning interface USS.
The actual values are displayed on an intelligent operator panel (IOP).
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
r2019[0...7] Comm IF error statistics / Comm err
Access level: 4
Can be changed: -
Unit group: -
Min
-
Description: Displays the receive errors at the commissioning interface (USS, RS232).
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
9600 baud
19200 baud
38400 baud
57600 baud
76800 baud
93750 baud
115200 baud
Calculated: -
Scaling: -
Unit selection: -
Max
12
Calculated: -
Scaling: -
Unit selection: -
Max
31
Calculated: -
Scaling: 4000H
Unit selection: -
Max
-
Calculated: -
Scaling: -
Unit selection: -
Max
-
2 Parameters
2.2 List of parameters
Data type: Integer16
Dyn. index: -
Func. diagram: -
Factory setting
12
Data type: Unsigned16
Dyn. index: -
Func. diagram: -
Factory setting
2
Data type: U32 / Integer16
Dyn. index: -
Func. diagram: -
Factory setting
0
Data type: Unsigned32
Dyn. index: -
Func. diagram: -
Factory setting
-
269