Parameters For Write Protection And Know-How Protection - Siemens SINAMICS G120D CU240D-2 DP Manual

2.5

Parameters for write protection and know-how protection

2.5.1 Parameters with "WRITE_NO_LOCK"
The following list contains the parameters with the "WRITE_NO_LOCK" attribute.
These parameters are not affected by the write protection.
Product: SINAMICS G120D, Version: 4707900, Language: eng, Type: WRITE_NO_LOCK
p0003
p0010
p0124[0...n]
p0970
p0971
p0972
p2111
p3950
p3981
p3985
p7761
p8805
p8806[0...53]
p8807[0...15]
p8808[0...53]
p8809[0...53]
p9400
p9484
2.5.2 Parameters with "KHP_WRITE_NO_LOCK"
The following list contains the parameters with the "KHP_WRITE_NO_LOCK" attribute.
These parameters are not affected by the know-how protection.
Product: SINAMICS G120D, Version: 4707900, Language: eng, Type: KHP_WRITE_NO_LOCK
p0003
p0010
p0124[0...n]
p0970
p0971
p0972
p2111
p3950
p3981
p3985
p7761
p8805
p8806[0...53]
p8807[0...15]
p8808[0...53]
p8809[0...53]
p8980
p8981
p8982
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
2.5 Parameters for write protection and know-how protection
Access level / Acc_level
Drive commissioning parameter filter / Drv comm. par_filt
CU detection via LED / CU detection LED
Reset drive parameters / Drive par reset
Save parameters / Save par
Drive unit reset / Drv_unit reset
Alarm counter / Alarm counter
Service parameter / Serv par
Faults acknowledge drive object / Faults ackn DO
Master control mode selection / PcCtrl mode select
Write protection / Write protection
Identification and maintenance 4 configuration / I&M 4 config
Identification and Maintenance 1 / I&M 1
Identification and Maintenance 2 / I&M 2
Identification and Maintenance 3 / I&M 3
Identification and Maintenance 4 / I&M 4
Safely remove memory card / Mem_card rem
BICO interconnections search signal source / BICO S_src srch
Access level / Acc_level
Drive commissioning parameter filter / Drv comm. par_filt
CU detection via LED / CU detection LED
Reset drive parameters / Drive par reset
Save parameters / Save par
Drive unit reset / Drv_unit reset
Alarm counter / Alarm counter
Service parameter / Serv par
Faults acknowledge drive object / Faults ackn DO
Master control mode selection / PcCtrl mode select
Write protection / Write protection
Identification and maintenance 4 configuration / I&M 4 config
Identification and Maintenance 1 / I&M 1
Identification and Maintenance 2 / I&M 2
Identification and Maintenance 3 / I&M 3
Identification and Maintenance 4 / I&M 4
Ethernet/IP profile / Eth/IP profile
Ethernet/IP ODVA STOP mode / Eth/IP ODVA STOP
Ethernet/IP ODVA speed scaling / Eth/IP ODVA n scal
2 Parameters
587