Siemens SINAMICS G120D CU240D-2 DP Manual page 167

p1075[0...n] CI: Suppl setp / Suppl setp
Access level: 3
Can be changed: T
Unit group: -
Min
-
Description: Sets the signal source for the supplementary setpoint.
Dependency: Refer to: p1076, r1077, r1078
p1076[0...n] CI: Supplementary setpoint scaling / Suppl setp scal
Access level: 3
Can be changed: T
Unit group: -
Min
-
Description: Sets the signal source for scaling the supplementary setpoint.
r1077 CO: Supplementary setpoint effective / Suppl setpoint eff
Access level: 3
Can be changed: -
Unit group: 3_1
Min
- [rpm]
Description: Displays the effective supplementary setpoint. The value shown is the additional setpoint after scaling.
r1078 CO: Total setpoint effective / Total setpoint eff
Access level: 3
Can be changed: -
Unit group: 3_1
Min
- [rpm]
Description: Displays the total effective setpoint.
The value indicates the sum of the effective main setpoint and supplementary setpoint.
p1080[0...n] Minimum speed / n_min
Access level: 1
Can be changed: C(1), T
Unit group: 3_1
Min
0.000 [rpm]
Description: Sets the lowest possible motor speed.
This value is not undershot in operation.
Dependency: Refer to: p1106
Notice: The effective minimum speed is formed from p1080 and p1106.
Note: The parameter value applies for both motor directions.
In exceptional cases, the motor can operate below this value (e.g. when reversing).
SINAMICS G120D
List Manual (LH14), 01/2016, A5E33842313
Calculated: -
Scaling: p2000
Unit selection: -
Max
-
Calculated: -
Scaling: PERCENT
Unit selection: -
Max
-
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: p2000
Unit selection: p0505
Max
- [rpm]
Calculated: -
Scaling: -
Unit selection: p0505
Max
19500.000 [rpm]
2 Parameters
2.2 List of parameters
Data type: U32 / FloatingPoint32
Dyn. index: CDS, p0170
Func. diagram: 3001, 3030
Factory setting
0
Data type: U32 / FloatingPoint32
Dyn. index: CDS, p0170
Func. diagram: 3001, 3030
Factory setting
1
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 3030
Factory setting
- [rpm]
Data type: FloatingPoint32
Dyn. index: -
Func. diagram: 3030
Factory setting
- [rpm]
Data type: FloatingPoint32
Dyn. index: DDS, p0180
Func. diagram: 3050, 8022
Factory setting
0.000 [rpm]
167