Atmf Domain Vlan - Allied Telesis x310-26FT Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF DOMAIN VLAN

atmf domain vlan
Overview The AMF domain VLAN is one of the internal VLANs that are used to communicate
information about the state of the AMF network between nodes. AMF uses its
internal VLANS (the management VLAN and the domain VLAN) to communicate its
inter nodal network status information. These VLANs must be reserved for AMF
and not used for other purposes.
When an AMF network is first created all its nodes are assigned a domain VLAN
with a default (domain) VID of 4091. An important point conceptually is that
although this VLAN then exists globally across the AMF network, it is assigned
separately to each domain. The AMF network therefore can be thought of as
comprising a series of domain VLANS each having the same VID and each being
applied to a horizontal slice (domain) of the AMF. It follows therefore that the
domain VLANs are only applied to ports that form cross-links and not to ports that
form uplinks/downlinks.
If you assign a VLAN ID to this VLAN (i.e. changing its value from the default of
4091) then you will need to do this separately on every device within the AMF
network. The AMF domain subnet will then be applied to this new VID when all
devices within the AMF network are next rebooted.
Use the no variant of this command to reset the VLAN ID to its default value of
4091.
atmf domain vlan <2-4090>
Syntax
no atmf domain vlan
Default The default domain VLAN ID for the AMF is 4091.
Mode Global Configuration
Usage The VLANs involved in this process must be reserved for AMF and cannot be used
for other purposes. This command enables you to change the domain VLAN to
match your network's specific configuration.
CAUTION
VLAN for the device being configured. The new domain VLAN will not become effective
for the AMF network until all its member nodes have been updated, and all its member
devices rebooted.
As part of its automatic creation process, this VLAN will also be assigned an IP
subnet address based on the value configured by the command
management subnet
C613-50103-01 REV A
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
<2-4090>
The VLAN number in the range 2 to 4090.
: Setting this command, then rebooting the device, will only apply the AMF
on page 2060. Refer to this command for more information.
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
atmf
2052