Allied Telesis Management Framework™ (Amf) Commands; Introduction - Allied Telesis x310-26FT Command Reference Manual

50

Introduction

This chapter provides an alphabetical reference for Allied Telesis Management
Framework™ (AMF) commands.
AMF master Every AMF network must have at least one master node, which acts as the core of
nodes the AMF network. Not all AlliedWare Plus devices are capable of acting as an AMF
master. See the
about AMF master support.
AMF edge GS900MX Series and XS900MX Series switches can only be used as edge switches
in an AMF network. The full management power and convenience of AMF is
available on these switches, but they can only link to one other AMF node. They
cannot form cross-links or virtual links.
AMF naming When AMF is enabled on a device, it will automatically be assigned a host name. If
convention a host name has already been assigned, by using the command
231, this will remain. If however, no host name has been assigned, then the name
applied will be the prefix, host_ followed (without a space) by the MAC address of
the device. For example, a device whose MAC address is 0016.76b1.7a5e will have
the name host_0016_76b1_7a5e assigned to it.
To efficiently manage your network using AMF, we strongly advise that you devise
a naming convention for your network devices, and accordingly apply an
appropriate hostname to each device in your AMF network.
Command List •
•
•
•
•
•
•
C613-50103-01 REV A
Framework™ (AMF)
AMF Feature Overview and Configuration Guide
"atmf area" on page 2025
"atmf area password" on page 2027
"atmf backup" on page 2029
"atmf backup area-masters
"atmf backup area-masters
"atmf backup area-masters
"atmf backup area-masters
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Allied Telesis
Management
Commands
delete" on page 2030
enable" on page 2031
now" on page 2032
synchronize" on page 2033
for information
hostname on page
2021