Ipv6 Mld Snooping Querier - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

MLD S C
NOOPING OMMANDS
6
IPV MLD SNOOPING QUERIER

ipv6 mld snooping querier

Overview Use this command to enable MLD querier operation on a subnet (VLAN) when no
multicast routing protocol is configured in the subnet (VLAN). When enabled, the
MLD Snooping querier sends out periodic MLD queries for all interfaces on that
VLAN.
Use the no variant of this command to disable MLD querier configuration.
ipv6 mld snooping querier
Syntax
no ipv6 mld snooping querier
Mode Interface Configuration for a specified VLAN interface.
Usage This command can only be configured on a single VLAN interface - not on multiple
VLANs.
The MLD Snooping querier uses the 0.0.0.0 Source IP address because it only
masquerades as an MLD querier for faster network convergence.
The MLD Snooping querier does not start, or automatically cease, the MLD Querier
operation if it detects query message(s) from a multicast router. It restarts as an
MLD Snooping querier if no queries are seen within the other querier interval.
Example awplus#
awplus(config)#
awplus(config-if)#
613-50157-01 Rev C
configure terminal
interface vlan2
ipv6 mld snooping querier
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
746