Date And Time - Hitachi Compute Blade 500 Series User Manual

No.
(15)
How to recover System Service to a normal state
Since the cursor is already placed on Force Recovery, just press [Enter] to
display a sub-screen. Select 'Yes', and press [Enter]. Force Recovery
processing takes about three minutes to complete. During the period, you will
not be able to perform any operations on LPAR manager.
Note:
• Operation with Force Recovery should be done when no LPAR is activated.
If you do with any LPAR in activation, network communication of the LPAR
is disconnected for a few minutes. SC/BSM displays Deactivate as LPAR
manager status, and no error message is provided.

Date and Time

Note:
• It is recommended to adjust the LPAR manager system time by using NTP
servers. If the LPAR manager is rebooted (including an unexpected LPAR
manager system failure and switching N+M) after running for a long time
without adjusting the LPAR manager system time, the time of guest OS
appear without adjustment.Be sure to save the configuration after NTP
setting is enabled. RTC time of LPAR might not synchronize as correction
time of NTP, if you rebooted without saving the configuration.
7-74
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
Item
Shared PCI Displays the status of the PCI device in the
Device Port shared scheduling mode on the [PCI Device
State Assignment] screen.
When Device Type is N shown in (7):
U: Link Up status
D: Link Down status
E: The device cannot be used due to an
unrecoverable error.
-: The status is unknown.
Blank: Shared NIC is not defined.
When Device Type is F shown in (7):
A: Available. The device is in the normal
status and usable.
D: LinkDown. The device cannot be used
because no cable is connected to it.
C: ConfigCheck. The device cannot be used
because of a configuration problem.
E: ErrorCheck. The device cannot be used
because of an unrecoverable error.
Operation by LPAR manager Screen
Description
Supported
Default LPAR
Value manager
Version
D 01-0X~