Show Logging Auditlog - Dell S4810 Reference Manual

%RPM:0:0 %CHMGR-2-LINECARDDOWN - Line card 3 down - IPC timeout
Dell#

show logging auditlog

Displays an audit log.
Syntax
show logging auditlog
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0)
Example
Dell(conf)#show logging audit
Related clear logging auditlog
Commands
show logging driverlog stack-unit
Display the driver log for the specified stack member.
S4810
Syntax
show logging driverlog stack-unit unit#
Parameters
stack-unit
unit#
defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
1600
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
— clears audit log.
Enter the keywords stack-unit followed by the stack
member ID of the switch for which you want to display the
driver log. The range is from 0 to 7.
EXEC
EXEC Privilege
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Simple Network Management Protocol (SNMP) and Syslog