Show Logging - Dell S4810 Reference Manual

Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage To block a type of message parameter, set the logging trap level to a lower
Information number. For example, to block severity messages at level 6, set the level to 5.
Related
logging
Commands
logging on

show logging

Display the logging settings and system messages logged to the internal buffer of the switch.
S4810
Syntax
show logging [number | history [reverse][number] | reverse
[number] | summary]
Parameters
number
history
reverse
summary
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Simple Network Management Protocol (SNMP) and Syslog
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series, S55.
Introduced on the C-Series.
— enables the logging to another device.
— enables logging.
(OPTIONAL) Enter the number of messages displayed in the
output. The range is from 1 to 65535.
(OPTIONAL) Enter the keyword history to view only
information in the Syslog history table.
(OPTIONAL) Enter the keyword reverse to view the Syslog
messages in FIFO (first in, first out) order.
(OPTIONAL) Enter the keyword summary to view a table
showing the number of messages per type and per slot. Slots
*7* and *8* represent RPMs.
EXEC
EXEC Privilege
1595