Show Logging Auditlog - Dell Z9500 Reference Manual

Feb 18 00:43:10: %SYSTEM:CP %IFMGR-5-ASTATE_DN: Changed
interface Admin state to down: Fo 2/0
Feb 18 00:43:07: %SYSTEM:CP %SYS-5-CONFIG_I: Configured from
vty0 ( 10.16.127.145 )by admin
- repeated 6 times
Feb 18 00:42:44: %SYSTEM:CP %SYS-5-CONFIG_I: Configured from
vty0 ( 10.16.127.145 )by admin
Feb 18 00:42:44: %SYSTEM:CP %IFMGR-5-ASTATE_UP: Changed
interface Admin state to up: Fo 2/0
Feb 18 00:42:38: %SYSTEM:CP %SEC-3-
AUTHENTICATION_ENABLE_SUCCESS: Enable password authentication
success on vty0 ( 10.16.127.145 )
Feb 18 00:42:38: %SYSTEM:CP %SEC-5-LOGIN_SUCCESS: Login
successful for user admin on line vty0 ( 10.16.127.145 )
Feb 18 00:39:38: %SYSTEM:CP %SYS-5-CONFIG_I: Configured from
console
--More--
Example
Dell#show logging history
(History)
Syslog History Table: 1 maximum table entries,
saving level warnings or higher
SNMP notifications not Enabled
Feb 18 01:16:57: %SYSTEM:CP %SEC-3-
AUTHENTICATION_ENABLE_SUCCESS: Enable password authentication
success on vty0 ( 10.16.127.145 )

show logging auditlog

Displays an audit log.
Syntax
show logging auditlog
Defaults none
Command EXEC
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.5(0.1)
9.5(0.0)
Example
Dell(conf)#show logging audit
Related clear logging auditlog
Commands
Simple Network Management Protocol (SNMP) and Syslog
Description
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL.
— clears audit log.
1699