Clear Spantree Adminedge - Enterasys N Standalone (NSA) Series Configuration Manual

6.2.2.21

clear spantree adminedge

Use this command to reset a Spanning Tree port to non-edge status.
clear spantree adminedge port-string
Syntax Description
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset fe.1.11 as a non-edge port:
Matrix(rw)->clear spantree adminedge fe.1.11
Specifies port(s) on which to reset edge port status. For a
detailed description of possible port-string values, refer to
Section 4.1.1.
Matrix NSA Series Configuration Guide
Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
6-113