Port String Syntax Used In The Cli - Enterasys N Standalone (NSA) Series Configuration Manual

Port Configuration Summary

Port String Syntax Used in the CLI

4.1.1 Port String Syntax Used in the CLI
Commands requiring a port-string parameter use the following syntax to designate port type, slot
location, and port number:
port type.port group.port number
Where port type can be:
fe for 100-Mbps Ethernet
ge for 1-Gbps Ethernet
com for COM (console) port
host for the host port
vlan for vlan interfaces
lag for IEEE802.3 link aggregation ports
lpbk for loopback interfaces, or
lo for the local (software loopback) interface
bp for FTM1 backplane ports
pc for the internal ports which connect to the on-board processor of an installed Matrix Security
Module
rtr for router interface
Port group can be:
1 for the lower fixed front panel ports
2 for the middle fixed front panel ports, or
3 for the top fixed front panel ports and the Mini-GBIC uplink ports
Port number can be:
Any port number in a port group.
Examples
NOTE: You can use a wildcard (*) to indicate all of an item. For example, fe.3.* would
represent all 100Mbps Ethernet (fe) ports in in port group 3.
This example shows the port-string syntax for specifying the 100-Mbps Ethernet ports 1 through
10 in port group 1.
fe.1.1-10
4-2 Matrix NSA Series Configuration Guide