Set Netflow Template - Enterasys N Standalone (NSA) Series Configuration Manual

11.2.8.12 set netflow template

Use this command to configure the NetFlow Version 9 template refresh rate and/or timeout values.
set netflow template {[refresh-rate packets] [timeout minutes]}
Syntax Description
refresh-rate
packets
timeout minutes
Command Defaults
At least one of the refresh-rate or timeout parameters must be specified, although
both can be specified on one command line.
Command Type
Switch command.
Command Mode
Read-Write
Usage
Version 9 template records have a limited lifetime and must be periodically
refreshed. Templates are retransmitted when either:
•
•
Template refresh based on the timeout period is only performed by the master DFE
blade, to avoid multiple copies being sent to the collector. Since each DFE blade
handles its own packet transmissions, template refresh based on number of export
packets sent is managed by each blade independently.
The number of export packets sent that causes a template
to be retransmitted by an individual DFE blade.
The value of packets can range from 1 to 600. The default
value is 20 packets.
The length of the timeout period, in minutes, after which
a template is retransmitted by the master DFE blade in the
system.
The value of minutes can range from 1 to 3600. The
default value is 30 minutes.
The packet refresh rate is reached, or
The template timeout is reached.
Logging And Network Management Command Set
Matrix NSA Series Configuration Guide
Configuring NetFlow
11-167