Set Policy Rule - Enterasys N Standalone (NSA) Series Configuration Manual

8.3.2.4

set policy rule

Use this command to assign incoming untagged frames to a specific policy profile and to VLAN or
Class-of-Service classification rules.
set policy rule admin-profile | profile-index {ether | ipfrag | ipproto | ipdest |
ipsource | iptos | llcDsapSsap | macdest | macsource | | port | tcpdestport |
tcpsourceport | udpdestport | udpsourceport} data [mask mask] [port-string
port-string] [storage-type {non-volatile | volatile}] [vlan vlan] | [drop | forward]
[admin-pid admin-pid] [cos cos]
NOTE: Classification rules are automatically enabled when created.
Syntax Description
admin-profile |
profile-index
ether
ipdest
ipfrag
ipproto
ipsource
iptos
llcDsapSsap
macdest
macsource
port
tcpdestport
Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Specifies that this is an administrative rule or associates
this classification rule with a policy profile index
configured with the set policy profile command
(Section 8.3.1.2). Valid profile-index values are 1- 1023.
NOTE: Admin profiles can be assigned to a
specific ingress port by specifying port-string
and admin-pid values as described below.
Classifies based on type field in Ethernet II packet.
Classifies based on destination IP address.
Classifies based on IP fragmentation value.
Classifies based on protocol field in IP packet.
Classifies based on source IP address.
Classifies based on Type of Service field in IP packet.
Classifies based on DSAP/SSAP pair in 802.3 type
packet.
Classifies based on MAC destination address.
Classifies based on MAC source address.
Classifies based on port-string.
Classifies based on TCP destination port with.
Matrix NSA Series Configuration Guide 8-31