Enterasys N Standalone (NSA) Series Configuration Manual page 1019

12.2.8.26 set router limits
Use this command to set LSNAT router limits.
set router limits [lsnat-bindings lsnat-bindings] | [lsnat-cache lsnat-cache] |
[lsnat-configs lsnat-configs]
NOTE: This command must be executed from the switch CLI.
Syntax Description
lsnat-bindings
lsnat-bindings
lsnat-cache
lsnat-cache
lsnat-configs
lsnat-configs
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
•
•
•
(Optional) Sets the LSNAT maximum bindings limit.
(Optional) Sets the LSNAT cache size limit.
(Optional) Sets the LSNAT configuration limit for number
of server farms, virtual servers, direct access entries, real
servers, and client access entries.
The lsnat-configs value can range from 1 to 50. The number
specified will have the following effect:
•
•
If not specified, maximum bindings will be set to the default value of 5000.
If not specified, cache size will be set to the default value of 1000.
If not specified, maximum configs will be set to the default value of 50. That
is, up to 50 server farms, 50 virtual servers, and 50 direct access entries can be
Configuring Load Sharing Network Address Translation (LSNAT)
1 to 50 server farms, virtual servers, and direct access
entries can be configured
10 to 500 real servers and client access entries can be
configured
Matrix NSA Series Configuration Guide
IP Configuration Command Set
12-107