Enterasys N Standalone (NSA) Series Configuration Manual page 935

12.2.4.3 ip gratuitous-arp
Use this command to
ip gratuitous-arp {ignore | reply | request}
Syntax Description
ignore
reply
request
Command Syntax of the "no" Form
The "no" form of this command resumes default ARP processing as
described in RFC 826
ARP reply or request.
no ip gratuitous-arp
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to enable ARP updating from gratuitous ARP requests on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip gratuitous-arp request
override the normal ARP updating process, that occurs by default.
Ignore all gratuitous ARP frames, no updates will occur.
This option will also prevent any new learning from
gratuitous arps, if the command ip gratuitous-arp-learning
was
Update from gratuitous arp reply only.
Update from gratuitous arp request only.
, update an existing ARP entry from either a gratuitous
Reviewing and Configuring the ARP Table
used.(Section 12.2.4.4).
Matrix NSA Series Configuration Guide
IP Configuration Command Set
12-23