Set Snmp Access - Enterasys N Standalone (NSA) Series Configuration Manual

SNMP Configuration Command Set
Configuring SNMP Access Rights
5.3.3.2

set snmp access

Use this command to set an SNMP access configuration.
set snmp access groupname security-model {v1 | v2c | usm} [noauthentication
| authentication | privacy] [context context] [exact | prefix] [read read] [write
write] [notify notify] [volatile | nonvolatile]
Syntax Description
groupname
security-model v1 |
v2c | usm
noauthentication |
authentication |
privacy
context context
exact | prefix
read read
write write
notify notify
volatile |
nonvolatile |
read-only
5-30 Matrix NSA Series Configuration Guide
Specifies a name for an SNMPv3 group.
Specifies SNMP version 1, 2c or 3 (usm).
(Optional) Applies SNMP security level as no
authentication, authentication (without privacy) or
privacy. Privacy specifies that messages sent on behalf of
the user are protected from disclosure.
(Optional) Sets the context for this access configuration
and specifies that the match must be exact (matching the
whole context string) or a prefix match only. Context is a
subset of management information this SNMP group will
be allowed to access. Valid values are full or partial
context names. To review all contexts configured for the
device, use the show snmp context command as
described in Section
NOTE: A routing module must be specified as
a context to allow for SNMP management when
operating in router mode.
(Optional) Specifies a read access view.
(Optional) Specifies a write access view.
(Optional) Specifies a notify access view.
(Optional) Stores associated SNMP entries as temporary
or permanent, or read-only.
5.3.4.2.