Ip Dhcp Ping Timeout - Enterasys N Standalone (NSA) Series Configuration Manual

IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12.2.9.5

ip dhcp ping timeout

Use this command to specify the amount of time the DHCP server will wait for a ping reply from
an IP address before timing out.
ip dhcp ping timeout milliseconds
Syntax Description
number
Command Syntax of the "no" Form
The "no" form of this command resets the ping timeout to the default value of 500:
no ip dhcp ping timeout
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to set the DHCP ping timeout to 900 milliseconds:
Matrix>Router1(config)#ip dhcp ping timeout 900
12-118 Matrix NSA Series Configuration Guide
Specifies the ping timeout in milliseconds. Valid values are
100 to 10000.