Set Spantree Adminpathcost - Enterasys N Standalone (NSA) Series Configuration Manual

6.2.2.17

set spantree adminpathcost

Use this command to set the administrative path cost on a port and one or more Spanning Trees.
set spantree adminpathcost port-string cost [sid sid]
NOTE:
By default, this value is set to 0, which forces the port to recalculate Spanning
Tree path cost based on the speed of the port and whether or not legacy path cost is
enabled. For details on using the
Section 6.2.1.43.
Syntax Description
port-string
cost
sid sid
Command Defaults
If sid is not specified, admin path cost will be set for Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the admin path cost to 200 for fe.3.2 on SID 1:
Matrix(rw)->
set spantree legacypathcost
Specifies the port(s) on which to set an admin path cost.
For a detailed description of possible port-string values,
refer to Section 4.1.1
Specifies the port path cost. Va1id values are:
•
0 - 65535 if legacy path cost is enabled.
•
0 - 200000000 if legacy path cost is disabled.
(Optional) Sets the admin path cost for a specific
Spanning Tree identifier. Valid values are 0 - 4094. If not
specified, SID 0 will be assumed.
set spantree adminpathcost fe.3.2 200 sid 1
Spanning Tree Configuration Command Set
Configuring Spanning Tree Port Parameters
.
Matrix NSA Series Configuration Guide
command, refer to
6-109