Logging And Network Management Command Set
Configuring Simple Network Time Protocol (SNTP)
11.2.6.14 show timezone
Use this command to display SNTP time zone settings.
show timezone
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNTP time zone settings:
Matrix(rw)->show timezone
Admin Config timezone: '', offset from UTC is 5 hours and 0 minutes
Oper
Config timezone: '', offset from UTC is 5 hours and 0 minutes
11-136 Matrix NSA Series Configuration Guide