Table of Contents
Advertisement
General Configuration Command Set
Setting Basic Device Properties
2.2.3
Setting Basic Device Properties
Module, slot, and certain other hardware-based parameters in the Matrix N Series Standalone
(NSA) CLI support only chassis based N Series devices, such as the N7, N5, N3 or N1. Executing
commands in the NSA CLI with modular parameters not supported by the standalone will result in
an error message.
Purpose
To display and set the system IP address and other basic system (device) properties, including time,
contact name and alias, physical asset IDs for terminal output, timeout, and version information.
Commands
The commands used to set basic system information are listed below and described in the associated
section as shown.
•
show ip address
•
set ip address
(Section
•
clear ip address
•
show ip gratuitous-arp
•
set ip gratuitous-arp
•
clear ip gratuitous-arp
•
show system
(Section
•
show system hardware
•
show system utilization
•
set system utilization threshold
•
clear system utilization
•
show time
(Section
•
set time
(Section
•
show summertime
•
set summertime
2-42 Matrix NSA Series Configuration Guide
Module / Slot Parameters in the NSA CLI
(Section
2.2.3.1)
2.2.3.2)
(Section
2.2.3.3)
(Section
2.2.3.4)
(Section
2.2.3.5)
(Section
2.2.3.6)
2.2.3.7)
(Section
2.2.3.8)
(Section
2.2.3.9)
(Section
(Section
2.2.3.11)
2.2.3.12)
2.2.3.13)
(Section
2.2.3.14)
(Section
2.2.3.15)
2.2.3.10)
Advertisement
Chapters
Table of Contents
