Set Snmp Community - Enterasys N Standalone (NSA) Series Configuration Manual

5.3.2.8

set snmp community

Use this command to configure an SNMP community group.
set snmp community community [securityname securityname] [context context]
[transport transport] [volatile | nonvolatile]
Syntax Description
community
securityname
securityname
context context
transport transport (Optional) Specifies the set of transport endpoints from
volatile |
nonvolatile
Command Defaults
None.
•
•
•
•
Command Type
Switch command.
Specifies a community group name.
(Optional) Specifies an SNMP security name to associate
with this community.
(Optional) Specifies a subset of management information
this community will be allowed to access. Valid values are
full or partial context names. To review all contexts
configured for the device, use the show snmp context
command as described in
which SNMP request with this community name will be
accepted. Makes a link to a target address table.
(Optional) Specifies the storage type for these entries.
If securityname is not specified, the community name will be used.
If context is not specified, access will be granted for the default context.
If transport tag is not specified, none will be applied.
If storage type is not specified, nonvolatile will be applied.
SNMP Configuration Command Set
Configuring SNMP Users, Groups and Communities
Section
NOTE: A routing module must be specified as
a context to allow for SNMP management when
operating in router mode.
Matrix NSA Series Configuration Guide
5.3.4.2.
5-23