Set Spantree Legacypathcost - Enterasys N Standalone (NSA) Series Configuration Manual

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6.2.1.43

set spantree legacypathcost

Use this command to enable or disable legacy (802.1D) path cost values.
set spantree legacypathcost {disable | enable}
NOTE:
path costs affects the range of valid values that can be entered in the
adminpathcost
Syntax Description
disable | enable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the default path cost values to 802.1D:
Matrix(rw)->set spantree legacypathcost enable
6-56 Matrix NSA Series Configuration Guide
By default, legacy path cost is disabled. Enabling the device to calculate legacy
command
Enables or disables legacy (802.1D) path cost values.
(Section 6.2.2.17).
set spantree