Show Spantree Legacypathcost - Enterasys N Standalone (NSA) Series Configuration Manual

6.2.1.42

show spantree legacypathcost

Use this command to display the default Spanning Tree path cost setting.
show spantree legacypathcost
Syntax Description
None.
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the default Spanning Tree path cost setting:
Matrix(rw)->show spantree legacypathcost
Legacy Path Cost is disabled
Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
Matrix NSA Series Configuration Guide 6-55