Enterasys N Standalone (NSA) Series Configuration Manual page 849

Enterasys networks switch configuration guide
Table of Contents

Advertisement

-x
host
packetlen
Command Defaults
Command Type
Switch command.
Command Mode
Read-Only.
(Optional) Prevents traceroute from calculating
checksums.
Specifies the host to which the route of an IP packet will
be traced.
(Optional) Specifies the length of the probe packet.
If not specified, waittime will be set to 5 seconds.
If not specified, first-ttl will be set to 1 second.
If not specified, max-ttl will be set to 30 seconds.
If not specified, port will be set to 33434.
If not specified, nqueries will be set to 3.
If -r is not specified, normal host routing tables will be used.
If -d is not specified, the debug socket option will not be used.
If not specified, tos will be set to 0.
If -F is not specified, the 'don't fragment' bit will not be applied.
If gateway is not specified, none will be applied.
If -I is not specified, UDP datagrams will be used.
If -v is not specified, summary output will be displayed.
If -x is not specified, checksums will be calculated.
Logging And Network Management Command Set
Managing Switch Network Addresses and Routes
Matrix NSA Series Configuration Guide
11-107

Advertisement

Table of Contents
loading

This manual is also suitable for:

Matrix n standalone series

Table of Contents