Show Spantree Backuproot - Enterasys N Standalone (NSA) Series Configuration Manual

Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6.2.1.65

show spantree backuproot

Use this command to display the state of the Spanning Tree backup root function.
show spantree backuproot [sid]
Syntax Description
sid
Command Defaults
If sid is not specified, status will be shown for Spanning Tree 0.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display the status of the backup root function on SID 0:
Matrix(rw)->show spantree backuproot
Backup Root is set to disable on sid 0
6-78 Matrix NSA Series Configuration Guide
(Optional) Displays status for a specific Spanning Tree.
Valid values are 0 - 4094. If not specified, SID 0 is
assumed.