Clear Cdp - Enterasys N Standalone (NSA) Series Configuration Manual

3.2.2.6

clear cdp

Use this command to reset CDP discovery protocol settings to defaults.
clear cdp {[state] [port-state port-string] [interval] [hold-time] [auth-code]}
Syntax Description
state
port-state
port-string
interval
hold-time
auth-code
Command Defaults
At least one optional parameter must be entered.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to reset the CDP state to auto-enabled:
Matrix(rw)->clear cdp state
(Optional) Resets the global CDP state to auto-enabled.
(Optional) Resets the port state on specific port(s) to
auto-enabled.
(Optional) Resets the message frequency interval to 60
seconds.
(Optional) Resets the hold time value to 180 seconds.
(Optional) Resets the authentication code to 16 bytes of 00
(00-00-00-00-00-00-00-00).
Matrix NSA Series Configuration Guide
Discovery Protocols Command Set
Enterasys Discovery Protocol
3-11