Ip Pim Rp-Address - Enterasys N Standalone (NSA) Series Configuration Manual

IP Configuration Command Set
Configuring PIM
12.2.7.4

ip pim rp-address

Use this command to set a static rendezvous point (RP) for a multicast group.
ip pim rp-address rp-address group-address group-mask [priority priority]
Syntax Description
rp-address
group-address
group-mask
priority priority
Command Syntax of the "no" Form
The no form of this command removes the static RP configuration:
no ip rp-address rp-address group-address group-mask
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
If not specified, a priority value of 192 will be assigned.
Example
This example sets a static RP address at 10.0.0.1 for the multicast group at 235.0.0 255.0.0:
Matrix>Router1(config)#ip pim rp-address 10.0.0.1 235.0.0.0. 255.0.0.0
12-52 Matrix NSA Series Configuration Guide
Specifies the IP address of the PIM RP router.
Specifies the multicast group address.
Specifies the multicast group mask.
(Optional) Specifies an RP priority value, ranging from 0 -
255. Lower values assign higher priority.