Show Spantree Nonforwardingreason - Enterasys N Standalone (NSA) Series Configuration Manual

6.2.3.21

show spantree nonforwardingreason

Use this command to display the reason for placing a port in a non-forwarding state due to an
exceptional condition.
show spantree nonforwardingreason [port port-string] [sid sid]
Syntax Description
port-string
sid sid
Command Defaults
If no port-string is specified, non-forwarding reason is displayed for all ports.
If no SID is specified, SID 0 is assumed.
Command Type
Switch command.
Command Mode
Read-Only.
Usage
Exceptional conditions causing a port to be placed in listening or blocking state
include a Loop Protect event, receipt of disputed BPDUs, and loopback detection.
Example
This example shows how to display the non-forwarding reason on ge.1.1:
Matrix(rw)->show spantree nonforwardingreason port ge.1.1
Port ge.1.1 has not been placed in a non-forwarding state on SID 0
due to any exceptional condition.
Configuring Spanning Tree Loop Protect Features
(Optional) Specifies port(s) for which to display the
non-forwarding reason. For a detailed description of
possible port-string values, refer to
(Optional) Specifies the specific Spanning Tree(s) for
which to display the non-forwarding reason. Valid values
are 0 - 4094. If not specified, SID 0 is assumed.
Matrix NSA Series Configuration Guide
Spanning Tree Configuration Command Set
Section 4.1.1.
6-143