Ip Local Pool - Enterasys N Standalone (NSA) Series Configuration Manual

12.2.9.2

ip local pool

Use this command to configure a local address pool to use as a DHCP subnet. This defines the range
of IP addresses to be used by DHCP server and enables IP local pool configuration mode.
ip local pool name subnet mask
Syntax Description
name
subnet
mask
Command Syntax of the "no" Form
The "no" form of this command removes the local address pool:
no ip local pool name subnet mask
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to configure a local address pool called "localpool" on IP subnet
172.20.28.0/24. Mask can also be expressed as 255.255.255.0:
Matrix>Router1(config)#ip local pool 172.20.28.0/24
Matrix>Router1(ip-local-pool)#
Configuring Dynamic Host Configuration Protocol (DHCP)
Specifies a name for the local address pool.
Specifies an IP subnet for the local address pool.
Specifies a subnet mask for the local address pool. Valid
entries are: x.x.x.x or /x.
Matrix NSA Series Configuration Guide
IP Configuration Command Set
12-115