3.2.2.1
show cdp
Use this command to display the status of the CDP discovery protocol and message interval on one
or more ports.
show cdp [port-string]
Syntax Description
port-string
Command Defaults
If port-string is not specified, all CDP information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display CDP information for ports fe.1.1 through fe.1.9:
Matrix(rw)->show cdp fe.1.1-9
CDP Global Status
CDP Versions Supported
CDP Hold Time
CDP Authentication Code
0x0 0x0 0x0
CDP Transmit Frequency
Port
Status
-----------------
fe.1.1
auto-enable
fe.1.2
auto-enable
fe.1.3
auto-enable
fe.1.4
auto-enable
fe.1.5
auto-enable
fe.1.6
auto-enable
fe.1.7
auto-enable
fe.1.8
auto-enable
fe.1.9
auto-enable
(Optional) Displays CDP status for a specific port. For a
detailed description of possible port-string values, refer to
Section
4.1.1.
: enabled
: 0x0 0x38
: 180
: 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0 0x0
: 60
Discovery Protocols Command Set
Enterasys Discovery Protocol
Matrix NSA Series Configuration Guide
3-5