Enterasys N Standalone (NSA) Series Configuration Manual page 1028

IP Configuration Command Set
Configuring Dynamic Host Configuration Protocol (DHCP)
12.2.9.3 exclude
Use this command to exclude one or more addresses from a DHCP local address pool.
exclude ip-address number
Syntax Description
ip-address
number
Command Syntax of the "no" Form
The "no" form of this command removes the addresses from the list of addresses
excluded from the local pool:
no exclude ip-address number
Command Type
Router command.
Command Mode
IP Local Pool configuration: Matrix>Router1(ip-local-pool)#
Command Defaults
None.
Example
This example shows how to exclude 2 IP addresses beginning with 172.20.28.254 from the
"localpool" address pool:
Matrix>Router1(config)#ip local pool localpool
Matrix>Router1(ip-local-pool)#exclude 172.20.28.254 2
12-116 Matrix NSA Series Configuration Guide
Specifies the starting IP address to be excluded from this
pool.
Specifies the number of addresses to be excluded. Valid
values are 1 - 65535.