Enterasys N Standalone (NSA) Series Configuration Manual page 648

Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
tcpsourceport
udpdestport
udpsourceport
data
mask mask
port-string
port-string
storage-type
non-volatile |
volatile
vlan vlan
drop | forward
admin-pid
admin-pid
cos cos
Command Defaults
•
8-32 Matrix NSA Series Configuration Guide
Classifies based on TCP source port .
Classifies based on UDP destination port .
Classifies based on UDP source port .
(Not required for ipfrag classification.) Specifies the code
for a predefined classifier. This value is dependent on the
classification type entered. Refer to
values for each classification type.
(Optional) Specifies the number of significant bits to
match, dependent on the data value entered. Refer to
Table 8-3
data value.
(Optional) If admin-profile is specified, applies this
administratively-assigned rule to a specific ingress port.
Adds or removes this entry from non-volatile storage.
Classifies to a VLAN ID.
Specifies that packets within this classification will be
dropped or forwarded.
If admin-profile is specified, associates this rule with a
policy profile index ID. Valid values are 1 - 1023.
Specifies that this rule will classify to a Class-of-Service
ID. Valid values are 0 - 255, and can be configured using
the set cos settings command as described in
Section
forwarding behavior modification is desired.
If mask is not specified, all data bits will be considered relevant.
for valid values for each classification type and
NOTE: Matrix Series devices with firmware
versions 3.00.xx and higher also support this
alternative command to administratively assign
a profile rule to a port:
set policy port port-string admin-id
8.3.3.21. A value of -1 indicates that no CoS
Table 8-3 for valid