Managing Switch Network Addresses And Routes - Enterasys N Standalone (NSA) Series Configuration Manual

Logging And Network Management Command Set

Managing Switch Network Addresses and Routes

11.2.5 Managing Switch Network Addresses and Routes
Purpose
To display, add or delete switch ARP table entries, to enable or disable RAD (Runtime Address
Discovery) protocol, to display, add or delete IP routing table addresses, and to display MAC
address information.
Commands
Commands to manage switch network addresses and routes are listed below and described in the
associated section as shown.
•
show arp (Section
•
set arp (Section
•
clear arp (Section
•
show rad (Section
•
set rad (Section
•
show ip route (Section
•
traceroute (Section
•
set ip route (Section
•
clear ip route (Section
•
show port mac (Section
•
show mac(Section
•
set mac (Section
•
clear mac (Section
•
show newaddrtrap
•
set newaddrtrap
•
show movedaddrtrap
•
set movedaddrtrap
11-98 Matrix NSA Series Configuration Guide
11.2.5.1)
11.2.5.2)
11.2.5.3)
11.2.5.4)
11.2.5.5)
11.2.5.6)
11.2.5.7)
11.2.5.8)
11.2.5.9)
11.2.5.10)
11.2.5.11)
11.2.5.12)
11.2.5.13)
(Section 11.2.5.14)
(Section 11.2.5.15)
(Section 11.2.5.16)
(Section 11.2.5.17)