Table of Contents
Advertisement
2.2.8
Managing Configuration and Image Files
Matrix Series devices provide a single configuration interface which allows you to perform both
switch and router configuration with the same command set. The Matrix Series devices now support
a script feature that allows you to execute a previously created script file containing CLI commands,
and at the time of execution, enter optional arguments that modify the actions of the commands.
This feature is intended to simplify the configuration of ports and VLANs, by creating script files
containing groups of commands that you want to run on the same port-string or VLAN id. At the
time of execution, you pass in the port-string, VLAN id, and any other required arguments that you
want the commands to operate on. Refer to the script command,
The following section describes the command set for managing both switch and router
configuration.
For details on performing a basic routing configuration (while operating in router mode), refer to
Section
12.2.3.
For details on downloading a new firmware image, refer to
For details on reviewing and selecting the boot firmware image, refer to
NOTE: The commands described in this section manage both switch and router
configuration parameters, but must be executed from the switch CLI.
Purpose
To view, manage, and execute configuration and image files.
Commands
The commands used to view, manage, and execute configuration and image files are listed below
and described in the associated section as shown.
•
dir
(Section
2.2.8.1)
•
show file
(Section
•
show config
(Section
•
configure
(Section
•
copy
(Section
2.2.8.5)
•
delete
(Section
2.2.8.6)
•
script
(Section
2.2.8.7)
2.2.8.2)
2.2.8.3)
2.2.8.4)
General Configuration Command Set
Managing Configuration and Image Files
Section
2.2.8.7.
Section
2.2.5.
Section
Matrix NSA Series Configuration Guide
2.2.6.
2-107
Advertisement
Chapters
Table of Contents
